FRM220-10GC-TS 10G Ethernet Media Converter

10G Ethernet Media Converter

The FRM220-10GC-TS is a copper to fibre 10Gbps Ethernet media converter based on IEEE802.3an and IEEE802.3ae. With SNMP and Web-based management in the FRM220, the Network administrator can monitor, configure and control the activity of each card in the chassis. This converter uses Cat.6a/Cat 7 twisted pair cable as copper transmission media with RJ-45 and 10G optical solution with SFP+ LC connector. The data stream can be converted bi-directionally from 10GBase-T to 10GBase-R and vice versa. With full duplex wire speed forwarding capability between these two media, The FRM220-10GC-TS brings you the best and simplest solution for the 10G Ethernet conversion between copper wire and fibre.

10G Ethernet Media Converter schematic


  • Network Management via FRM220 Chassis
  • Complies with IEEE802.3an 10GBase-T and IEEE802.3ae 10GBase-R
  • Real-Time conversion between 10GBase-T and 10GBase-R
  • Common used SFP+ fibre interface and RJ45 connector
  • Full duplex wire speed forwarding
  • Forwarding l8k bytes jumbo packet
  • Loopback Test
  • Link Fault Pass Through
  • Fibre Fault Alert
  • IEEE 802.1q VLAN pass through
  • Supports manual Dip Switch for quick set up


Optical Interface:

Connector: SFP+ LC
Data rate: 10Gbps
Distance: 300m, 10km, 40km, 80km
Wavelength: 1550nm, 1310nm, 850nm, WDM

Electrical Interface:

Connector: RJ45
Data rate: 10Gbps
RS-232: RJ45
Cable type: Cat.6a, 7
Distance: 95 meters (Cat.7)

Management Console port: RS-232 via CH01M, DIP Switch with CH01

Standard: IEEE 802.3an, IEEE 802.3ae
LEDs: SFP+, LR, Link/Act, LBK A/B, SYS
Power: 12VDC
Power Consumption: < 12W
Dimensions Card: 155 x 88 x 20.8mm (D x W x H)
Weight: 130g
Temperature: 0 ~ 50°C (Operating), -10 ~ 70°C (Storage)
Humidity: 0 ~ 85% non-condensing
Certification: CE, FCC
MTBF: 57,000 hrs