C6210 Series - DS3 – T3/E3 Coax to Fibre Network Interface Device
The C6210 DS3 – T3/E3 copper to fibre network interface device (NID) provides a solution for those users that need to extend DS3 connections over fibre. The DS3 – T3/E3s supports Small Form Pluggable (SFP) transceivers to support a variety of fibre types, distances and wavelengths to provide maximum flexibility across a variety of network topologies. The use of Coarse Wave Division Multiplexing (CWDM) SFPs can be utilized to further increase the bandwidth capacity of the fibre infrastructure. The DS3 – T3/E3 NID must be used in pairs. A typical installation will include a chassis card installed in the ION Platform locally and a stand-alone device installed at the remote location.
Features:
- AIS (Alarm Indication Signal)
- Coax Line Build Out
- Switch selectable for DS3/T3 or E3
- Remote firmware upgrade
- Loopback – Coax and Fibre
- LEDs for immediate visual status]
- Supports dual or single fibre
- Supports multimode and single mode fibre at a variety of distances
- Supports CWDM SFPs
- SNMP management when used with ION chassis and management module
- Remote standalone can be managed by local peer
Specifications:
Standards: ANSI, ITU-TS, ETSI, G.823 for jitter tolerance, G.755 for loss of signal
Coax Connectors: 75 ohm coax
Fibre Connectors:
- SFP: LC connector Uses standard 100BASE-X/OC-3 SFP
- Fixed Optics: ST or SC connector
Data Rates: DS3/T3 = 44.7Mbps; E3 = 34.4Mbps
Status LEDs: Power, Coax link status, coax loop-back status, AIS on coax link; Fibre link status, fibre loop-back status, AIS on fibre link
Dimensions: W: 0.86” [22 mm]; D: 6.5” [165 mm]; H: 3.4” [86 mm]
Power Consumption: 2.5 Watts
Shipping Weight: 1 lb. [.45 kg]
Regulatory Compliance: CISPR/EN55022 Class A; FCC Class A; CE Mark
MTBF: Greater than 250,000 hours (MIL-HDBD-217F); Greater than 687,000 hours (Bellcore)
Warranty: Lifetime